Most Popular FAQs
- How do I properly install HVE on my computer? ... (294 views)
- How do I start my simulation with the vehicle ... (259 views)
- Are there any issues when installing my HVE (or ... (224 views)
- I'm trying to accelerate a vehicle in reverse in ... (215 views)
- I am editing the exterior dimensions of a vehicle ... (214 views)
- When using EDSVS, why is the yaw moment of ... (205 views)
- Is there a list of cases in which results ... (202 views)
- I have a 16 second simulation run, but I ... (200 views)
- When I start my HVE or HVE-2D program, I ... (198 views)
- What is the difference between the three accelerations (Fwd ... (189 views)
Latest FAQs
- Is it possible to accelerate the vehicle backwards in ... (2012-02-07 00:34)
- I'm trying to add an environment, but when I ... (2012-02-07 00:32)
- How can I make my entire model/drawing display in ... (2012-02-07 00:30)
- I really appreciate the detailed information provided in the ... (2012-02-07 00:28)
- I am unable to open the Help Topics. ... (2011-12-28 23:45)
Physics Programs
ID #1063
When using EDSVS, why is the yaw moment of inertia that I enter in the Vehicle Inertias dialog diferent from the one reported in the Vehicle Data output report?
The value for yaw moment of intertia that you enter in the Vehicle Inertias dialog is the value about the vehicle's center of gravity, as expected. EDSVS is based on a model developed at the University of Michigan, TBST. In this model, the yaw moment of inertia is resolved about the geometric center of the vehicle. EDSVS uses the same logic. As for all variables, the value given in the output report is the value actually used by the program.
Tags: -
Related entries:
- I am editing the exterior dimensions of a vehicle from the EDVDB vehicle database and I do not see the geometry file scaling to match the new positions of the red spheres indicating the exterior dimensions of the vehicle. Why?
- Every now and then I find that the X-Y crosshair (dragger) manipulator for positioning a vehicle in the Event Editor disappears. If I move the camera inside the vehicle, I find that the manipulator is still present at the CG of the vehicle, but has become
- How do I start my simulation with the vehicle traveling in reverse?
- Why is it that when I try to do a rollover in EDVSM, the body of the vehicle falls right through the environment geometry as if it wasn't there?
- I notice that when I open an old case (pre-Version 7) and look at the Accident History output report in Playback, the units displayed at the top of each column and the corresponding numbers below are not correct. How do I fix this issue?
Last update: 2011-08-30 00:17
Author: EDC
Revision: 1.0
