Most popular FAQs 
- Are the data in the output reports updated when ... (29750 views)
- Every now and then I find that the X-Y ... (28836 views)
- How do I start my simulation with the vehicle ... (27931 views)
- I am unable to open the Help Topics. ... (27788 views)
- I recently installed Version 8 on my new computer ... (25001 views)
- When I try to install HVE, the process is ... (23803 views)
- Why am I getting "Bad or Incompatible Vehicle Data: ... (20829 views)
- When I start my HVE or HVE-2D program, I ... (20774 views)
- What can I do to get past an "Out ... (19549 views)
- I’m simulating a collision using SIMON/DyMESH involving two generic ... (19365 views)
Latest FAQs 
- I’m simulating a collision using SIMON/DyMESH involving two generic ... (2013-07-25 19:54)
- When I try to install HVE, the process is ... (2013-07-17 01:31)
- I can't get the selected output variables to display ... (2013-07-17 01:31)
- Why am I getting "Bad or Incompatible Vehicle Data: ... (2013-07-17 01:30)
- What can I do to get past an "Out ... (2013-07-17 01:30)
Physics Programs
ID #1027
I want to increase the inter-vehicle friction between two vehicles colliding with each other in my EDSMAC4 event. I used to find this in the Calculation Options for the event, but I don't see it listed there. Where do I make the adjustment?
If you are using EDSMAC for a crash simulation, the adjustment for Inter-vehicle Friction is located by selecting Options, Calculation Options on the main menu. You will clearly find the adjustment of Inter-vehicle Friction in the Calculation Options dialog.
If you are using EDSMAC4 or SIMON/DyMESH, the adjustment for Inter-vehicle Friction is found by first selecting a vehicle, then selecting Set-up, Vehicle Mesh. The third section of the Vehicle Mesh Options dialog allows the user to assign the Inter-Vehicle Friction value between the current vehicle and other vehicles in the simulation.
Tags: -
Related entries:
- I am editing the exterior dimensions of a vehicle from the EDVDB vehicle database and I do not see the geometry file scaling to match the new positions of the red spheres indicating the exterior dimensions of the vehicle. Why?
- I have a 16 second simulation run, but I only want to make a movie of the action from t = 5 seconds to t = 13.6 seconds. I've tried moving the slider to select the correct starting frame, but when I change the Destination to AVI and press the Play button
- Every now and then I find that the X-Y crosshair (dragger) manipulator for positioning a vehicle in the Event Editor disappears. If I move the camera inside the vehicle, I find that the manipulator is still present at the CG of the vehicle, but has become
- How do I start my simulation with the vehicle traveling in reverse?
- Why is it that when I try to do a rollover in EDVSM, the body of the vehicle falls right through the environment geometry as if it wasn't there?
Author: EDC
Revision: 1.0